My (rather old) washer blew through to me personally a weeks that are few (evidently this has been unbalanced for some time. Was included with the accepted destination and I never ever thought too much of the vibration until it absolutely was far too late.) and have always been getting a brandname brand new set delivered to my new set (Washer HERE, petrol Dryer HERE) from Sears on Thursday.

They desired about $80 plus parts to set up them (I forget I declined having just disconnected everything myself, I figured it would be easy enough to set up the new ones if it was each or for both) and. I am perhaps perhaps not specially handy but I am at about replace-my-own-ceiling-fan, remove-and-reinstall-my-own-garbage-disposal level.

I am perhaps perhaps not overly concerned with the washer, but I happened to be reviewing the manual for the dryer online and it offers me just a little nervous. It discusses the need to purge the fuel type of atmosphere twice, utilizing teflon tape (i did not see any proof of that regarding the old install), etc.

Therefore I wanted to pose the question- is it a thing that somebody within my degree are designed for myself or is there www.hookupwebsites.org/xcheaters-review/ enough gotchas that i ought to cough up the cash?

EDIT: we succeeded today thanks in big component towards the solution right here- many thanks.

I ended up buying ‘yellow’ gas-approved teflon tape and a brand new gas that is flexible (become safe. It had been $30 though!). And a dryer that is new hose (also pricey) since evidently I needed a steel one as well as the existing one had been foil.

It had been about as simple as We hoped.

1. I connected the (new) exhaust vent hose with the stress coupling bands ( maybe perhaps not certain the most suitable term) that was included with it on both edges- wall surface and appliance. The manual demanded to not make use of a foil vent, therefore I utilized a steel one. (regrettably, probably the most metal that is flexible I found pushes the dryer down too much through the wall surface for my requirements- i can not close the entranceway to my washing cabinet now. Subject of another post i suppose. I’ll try a “periscope” dryer vent.)
2. We connected the gas that is new into the valve in the wall surface, utilizing a layer of yellow teflon tape on the threads (although the Home Depot man appeared to think I would just require it from the appliance part)
3. We connected one of several detachable couplings from the gasoline line to your straight straight back associated with dryer (again, used tape despite the fact that maybe not necessary)
4. Switched on the fuel for the minute to purge the line
5. Loosely threaded the gasoline line into this coupling, additionally utilizing tape as suggested; purged once more
6. Tightened by having a (newly bought) pipe wrench.
7. Fired up the gasoline and listened & smelled for fuel at both connections – quiet and odorless 🙂

Took possibly half an hour, nearly all of that right time had been invested wrestling the stress couplings and looking to get the threads to take- was attempting to be really gentle.

Dryer started appropriate up no nagging dilemmas also it (and now we!) survived two test lots.

Therefore, went well, i came across it not too difficult and would try it again. Thank you for helping me build my skillset!

(Adding the photo that is requested though it’s a little late. Note that we covered the hard-gas-line’s opening with painter’s tape and stuck it on/around the valve so that you can not notice it, but it is here. Desired to protect it from all of the lint and dust going swimming down there.)